When you flip the material over, it will be in a known location, but you'll have to ensure that your inkscape files are properly aligned (also known as registered) with the flip. Anything placed firmly against these two rails will be in exactly the same place for each action performed on the work piece. It could be as simple as bolting scrap to the table, then cutting away that which is out of bounds of your cutting head. If you are using a full sheet of acrylic, place a rail on two adjacent sides on your cutting table. If the pressure in the clamp is not enough, the part may tend to rock, lift or spin in the pocket. It should be hard enough to hold it firmly, but soft enough to keep from damaging it. Cut off the tab and complete the finish.īe sure to use an appropriate material for the jig.Of the pocket as Z 0, cut the second half of the token. Using the same XY 0 as you used to create the pocket, and the depth.Place the token face down between the two pocket halves, using the. Would, but leave a small tab on the edge to align with the jig. Elsewhere on the table, cut the token's first side as you normally.Be sure not to cut away your top or side mark. Cut that pocketed piece in half, down the center so there are twoĮqual halves. Drill a top or side mark for alignment later.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |